The magnetoresistive rotation speed sensor CS-1-G-100-03-01 is a commonly used turbine speed sensor that plays an important role in various application scenarios. When installing the magnetoresistive speed sensor CS-1-G-100-03-01, you need to pay attention to the following points to ensure the normal operation and performance of the sensor.

First, be careful during the installation process to avoid damage to the sensor CS-1-G-100-03-01 housing thread. The integrity of the sensor housing thread is critical to the installation and stability of the sensor. If the thread is damaged, it may affect the installation of the sensor and even cause the sensor to fail to work properly.

Secondly, when tightening the CS-1-G-100-03-01 sensor, ensure that the hexagonal nut can rotate smoothly without any jamming. The smooth rotation of the hexagonal nut means that the sensor housing and the mounting component are well matched and unobstructed. If the hexagonal nut does not rotate smoothly, it may be because the thread is damaged or there is foreign matter between the sensor housing and the mounting component. Check and solve the problem in time to ensure the stability and reliability of the sensor.

In addition, during the installation process, make sure that the hexagonal nut is not loose after tightening. A loose hexagonal nut may cause the sensor to shift and affect its normal operation. After the installation is completed, check the sensor to ensure that the hexagonal nut has been tightened and is not loose.

When installing the magnetic resistance speed sensor CS-1-G-100-03-01, it is advisable that the gear being measured does not contact the sensor. Contact between the gear being measured and the sensor may cause damage to the sensor and affect its performance. During the installation process, ensure that there is a certain gap between the gear being measured and the sensor to avoid contact.

Finally, while ensuring that the gear being measured and the sensor CS-1-G-100-03-01 do not contact, the gap between them can be appropriately reduced to increase the output signal amplitude of the sensor. Too small a gap may cause the sensor output signal amplitude to increase, thereby improving the sensitivity and accuracy of the sensor. However, when adjusting the gap, it should be done under the premise of ensuring safety to avoid damage to the sensor due to too small a gap.

Yoyik can offer many spare parts for power plants as below:
LVDT Sensor 3000TDGN-100-01-01
Chain Broken Sensor BIY18-MD05NA-ZN
Probe CS-3-M16-L100
Main Control Board Include LCD Display SY-V2-CTRL (Ver 1.20)
Belt way sensor XD-TB-1-1230
Conductivity meter 2402B+2401B
MODULE, AUTOMATIC VOLTAGE CONTROL ESP I/O PORT PCB DN2001
FOXBORO Card FBM224
HMI SIMATIC TP900 6AV2124-0JC01-0AX0
Magnetic Rotational Speed Sensor CS-1 G-065-02-01
indicator RC860MZ091ZSS
flexible thermocouple probe WREK2-294
LVDT van điều chỉnh LP BFPT 268.33.01.01 (3)
Transmitter Vibrasi Fan Dual vibration monitor PDM1201-AXX-B1-C0-D1- E2-F0
TOUCH SWITCH SENSOR ALTS24V01
Magnetic Fow Meter DE43F/WT4300E DN700
Probe 9200-01-01-10-00
magnetic pick up sensor G-100-02-01
display controller GGAJ02 (TM-II)
rpm gauge sensor WZ-3C