Vacuum pump bearing P-2335 is one of the important accessories of the 30-WS vacuum pump unit. Although it is only a small component, its role in the entire pump unit cannot be ignored. Regular inspection and maintenance are crucial to ensure the efficient and stable operation of the pump unit.

Firstly, we need to check the oil level of vacuum pump bearing P-2335 daily and add oil if necessary. This is because the lubricating oil of the bearing components can not only reduce wear and reduce operating noise, but also dissipate heat and clean the friction surface. If the oil level is too low, it will lead to insufficient lubrication, which will exacerbate component wear; If the oil level is too high, it may cause oil seal leakage and affect the normal operation of the pump.

Secondly, we need to drain the water from the oil separator and valve box every week. After the vacuum value stabilizes, the overflow valve should be in the normally open position, which can ensure that the water in the oil-water separator can be discharged in a timely manner, avoiding the impact of water on the operation of the pump.

Next, we should also check the quality of the engine oil from the oil outlet of the separator every week. Normal engine oil should be clear and free of impurities. If emulsification, deterioration, or contamination of engine oil is found, it should be promptly purified or replaced. This is because inferior engine oil not only affects the operational efficiency of the pump, but may also cause damage to the equipment.

In addition, it is recommended to change the oil after 1-3 months of pump operation. Before replacement, it is necessary to drain the oil from the pump and clean the oil filter. Maintaining the cleanliness of lubricating oil is crucial for ensuring the capacity and service life of the pump.

Regularly adding lubricating grease to the end bearings, checking, adding or replacing the lubricating oil in the motor reducer, is also an important measure to maintain vacuum pump bearing P-2335. Every four months, this helps to reduce wear and prolong the service life of the equipment.

At the same time, check and remove impurities from the suction screen every four months to ensure the suction efficiency of the pump. Disassembling, inspecting, and cleaning the mist filter every year is an important step in ensuring the normal operation of the pump unit.

Finally, check the pump’s anchor bolts once a year to ensure they are securely fastened and prevent equipment failures caused by looseness.

Overall, for the maintenance of vacuum pump bearing P-2335, we need to be meticulous, regular, and timely. Only in this way can the efficient and stable operation of the vacuum pump unit be ensured, and the service life of the equipment is extended. In daily work, we should conscientiously carry out maintenance work to ensure the normal operation of the equipment. This is not only responsible for the equipment, but also a manifestation of responsibility for production and work.