The 2CY-12/6.3-1 gear pump has performed well in many industrial applications due to its efficient and stable self-priming ability and excellent operating performance. This article will provide a detailed introduction to the first start-up and idling of this type of gear pump and put forward specific operating suggestions.

The 2CY-12/6.3-1 gear pump is made of high-quality materials and advanced technology and has excellent self-priming performance. Its self-priming height can reach about 5 meters, which is suitable for the transportation of various oils and other media with similar viscosity. The internal structure of the gear pump is reasonably designed, and the liquid is sucked and discharged through the rotation of the gears, forming a good sealing effect, ensuring that the pump can quickly establish a vacuum and achieve self-priming when starting.

Adequate preparation: Before the first start, make sure that the pump body is filled with the medium to be transported to avoid damage to the pump caused by dry operation. At the same time, check whether the inlet pipeline of the pump is unobstructed and the outlet valve should be in the open state to ensure that the liquid can flow freely.

Preheating treatment: For the case of conveying high temperature or high viscosity media, the pump needs to be preheated before starting to make the media reach a suitable working temperature, reduce the starting resistance, and avoid difficulty in starting or damage to the pump due to excessive viscosity.

Check the seal: Confirm that all seals are intact, including shaft seals, stuffing boxes, etc., to prevent leakage. Check whether the coupling is properly aligned to avoid vibration and noise caused by poor alignment.

Monitor the operating status: After starting, closely observe the operating status of the pump, including pressure, flow, sound and vibration. Once an abnormality is found, stop the machine immediately for inspection to avoid the expansion of the fault.

Avoid long-term idling: Although the 2CY-12/6.3-1 gear pump has a certain dry running capability, long-term idling will accelerate the wear of the internal parts of the pump and reduce its service life. Therefore, it should be avoided to operate without media, especially during the initial startup and commissioning stage.

Gear pump 2CY-12/6.3-1 has become the preferred equipment in the field of industrial fluid transportation with its excellent self-priming performance and stable and reliable operation characteristics. However, correct operation and maintenance are the key to ensure its long-term and efficient operation. During initial startup and idling, following the above guidelines can effectively avoid potential risks, extend the service life of the pump, and ensure smooth production.

Yoyik offers various types of valves and pumps and its spare parts for power plants:
ROTARY FEEDER XG-100 (300X300)
Sinro Motorized Valve SR04GB32046B4
industrial hydraulic servo valves J761-003A
best float valve BYF-80
test solenoid valve 22FDA-K2T-W220R-20/LV
single entry centrifugal pump KSB50-250
straight stop shut off valve LJC50-1.6P
24 volt solenoid coil 300AA00126A
water in oil detector OWK-1G
screw vacuum pump P-545
SEAL LIP 90X62X10MM
valve trip F3DG5S2-062A-220DC-50-DFZK-V/B08
sealing oil re-circulating pump repair kit HSNH210-46A
gear box automatic M02225.013MVV1D1.5A
direct acting solenoid valve 4WE6Y-L6X/EG220NZ4-V/B08
mechanical seal Cartex SE/90-00
Oring A156.33.01.10-50X3.1
oil station screw pump HSNH440Q2-46N7
Pneumatic double slide valve Z644C-10T