The CS-1 D-100-02-01 speed sensor is a high-performance sensor designed specifically to meet the speed monitoring needs of steam turbines and other high-end equipment. It fully utilizes the principle of electromagnetic induction to achieve non-contact high-precision measurement. This design not only outputs strong signals, but also has excellent anti-interference ability, ensuring the accuracy and reliability of data in complex industrial environments. It is easy to install and has a wide range of applications, especially suitable for operation under harsh conditions such as smoke, oil and gas mixtures, and water vapor, providing a solid guarantee for industrial safety and efficiency.

However, although CS-1 D-100-02-01 was designed with full consideration for its adaptability to harsh environments, long-term exposure to such environments undoubtedly poses challenges to its performance and lifespan. Specifically, the following aspects need to be taken seriously:

1. Dust accumulation: In a dusty environment, small particles may gradually accumulate on the outer shell or sensing surface of the sensor, affecting its sensing performance and even leading to sensor blockage or poor heat dissipation.

2. Humidity and corrosion: A high humidity environment may not only cause corrosion of the internal circuit board of the sensor, but also lead to a decrease in insulation performance. In severe cases, it can cause short circuits or functional failure. In environments containing salt or other corrosive substances, the corrosion rate will be faster.

3. High temperature impact: Continuous high temperature environment can accelerate the aging of internal materials in sensors, reduce the performance of electronic components, and in severe cases, lead to sensor dysfunction or direct damage.

4. Oil, gas, and chemical pollution: Oil, gas, and other chemical pollutants may corrode the sensing components of sensors, alter their electromagnetic characteristics, reduce measurement accuracy, or cause permanent damage in extreme cases.

Given the aforementioned challenges, it is particularly important to take effective protective measures:

• Regular cleaning and maintenance: Ensure the external cleanliness of the sensor, and if necessary, perform professional cleaning to remove dust and dirt.

• Use protective covers or seals: Install protective covers or use models with higher sealing levels for sensors to isolate external pollutants, especially for humid and corrosive environments.

• Temperature control: If possible, control the temperature around the sensor through a fan, heat sink, or cooling system to prevent overheating.

• Regular inspection and calibration: Regularly inspect and calibrate the performance of sensors to ensure that their measurement accuracy is not affected by environmental factors and deviates.

Through these measures, the service life of sensor CS-1 D-100-02-01 in harsh environments can be maximized, ensuring its continuous provision of reliable and accurate speed monitoring services.

Yoyik can offer many spare parts for power plants as below:
Battery Holder Storage Box with Gold Plated Phosphor Bronze Pins 2×18650
Vacuum Low Voltage Switch PS531SPP10/BB32N3/S3M
PLC COMMUNICATION MODULE HY-6000VE/03
connection speed monitor DF9011 PRO
high precision proximity sensor PR6424/010-010
Oil pressure sensor 32302001001 0.08~0.01Mpa
LVDT Sensor 4000TD-15-01
LVDT sensor 4000td-xc3
Case Expansion Transducer TD-2-35
Terminal Module for Prosonic M FMU41
Actuator AOX-080
CPU BOARD FOR COAL FEEDER CS2024
CIO Input/Output Card PC D235
Electronic Module P223CB01BD5
Conductivity Meter 2402B
INTELLIGENT speed meter HY-01
Precision transient speed monitor DF9011
Vibration Monitoring Device & Protection Device Display Module HY6000VE
Voltage transducer WBV414S01
sensor DSD 1820.19 S22HW