The SZCB-01-B01 magnetoresistive speed sensor is a high-performance and widely used universal speed sensor used for measuring the speed of magnetic objects, using non-contact measurement methods. Yoyik tell you the installation of SZCB-01-B01 rotational speed sensor. You can follow the steps below:

1. Select installation location: Select an appropriate location to install the SZCB-01-B01 sensor. Normally, the sensor should be installed on the steam turbine shaft, close to the part where the speed needs to be measured. Ensure that the selected position facilitates the physical connection between the speed sensor and the shaft, and that the sensor can accurately sense the speed signal.

2. Preparation for installation location: Clean any dirt or grease on the shaft at the selected installation location. Ensure that the installation surface is smooth, clean, and free from any obstacles.

3. Install the sensor: fix the SZCB-01-B01 speed sensor on the selected mounting bracket. Ensure good physical contact between the sensor and the shaft, so that the sensor can accurately sense the speed signal. Depending on the design of the sensor, it may be necessary to use screws, fixtures, or other fixing devices to securely secure the sensor.

4. Connecting wires: Connect the wires of the sensor to the monitoring instrument or data collection system. According to the specifications of sensors and instruments, it may be necessary to perform correct wire wiring, such as using the correct wire type and connection method.

5. Testing and Calibration: After installation, perform testing and calibration to ensure that the SZCB-01-B01 speed sensor is functioning properly. Use monitoring instruments or data acquisition systems to monitor the speed signal and verify the accuracy of the sensor output.

The actual installation process may vary depending on the sensor model, turbine type, and manufacturer’s recommendations. YOYIK recommends referring to the specific installation manual of the sensor during the installation process.